detection of limit switch

help please
me and my friend , we are making a 3d printer reprap as a school project .
we have problem with detection of limit switch.
the tray of x axis keep going in the same direction after touching the swith .

and thank you

Check the wiring is intact. Send m119 with the switch pressed and not pressed see what result you get.

---

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions

Often this is an issue with axis being backwards and endstops being setup as mins or max's incorrectly

things to check. When looking at the front of the printer.

X+ moves head right, X- moves the head left. X min endstop is on the left, max on the right
Y+ moves the bed forward, Y- moves the bed back. Y min endstop is at the back, max at the front.
Z+ moves the head up, Z- moves the head down. Z min endstop is down and max is up.