PT100 temperature sensor question

I'm thinking of replacing my E3D thermistor cartridge with the PT100 setup.

Can I stick a connector in the cable without throwing off the readings or do the cables have to run straight to the adapter board?

PT100 ---- Connectors ------ Duet WiFi with adapter

or

PT100 --------------------------- Duet WiFi with adapter

I'd like to use a connector because it makes it easy to remove the effector platform on my Delta for maintenance, etc.

If you use a 2 wire connection from the PT100 to the interface, then any resistance in the connectors will increase the temperature reading. 0.4 ohms of resistance increases the reading by about 1C. You can avoid this by using a 4-wire connection. I described how to do this in my blog entry at [miscsolutions.wordpress.com].

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Thanks.