Hi I'm very new to 3d printing and I have just got my reprapguru prusa i3 printing and have really enjoyed it. I am using ramps 1.4/mega 2560 and Repetier with Slic3r. Yesterday the x-axis started to give me an endstop hit message when manually moving the extruder to the right. The problem is is that the actual endstop, on the left, was not engaged nor was the extruder near it. I took the endstop wire off of the endstop and from the connection on the board and the message will still display. I am able to maually move it until it actually hits the endstop and it will stop moving, like normal.
Like I said, I have been printing fairly well and it has been homing just fine on all of the axis' up until this point so I'm kind of at a loss as to what the problem could be. Also only once was I able to get it to go to the park position in the center of the bed. It wouldn't go to the park position after that first time.
Is there anything else I could check?