X-Axis keeps shifting to right

hi
my x axis is shifting allot on every print i do only to the right side. sometimes 5 cm sometimes 3cm. all my belts are tightened and rods lubricated. the voltage on my stepper drivers is 0.40V. i was having the same problem with the y axis and fixed it by adjusting the voltage to 0.4V, but thats not working on my x axis. my stepper drivers are not that hot either. my acceleration on the x axis is 900mm/s and my feedrate is 200mm/s
NVm solved problem by reducing acc from 100mm/s to 800mm/s

Edited 1 time(s). Last edit at 03/07/2017 09:21PM by sabeeh.

Hi glad you solved it, I take it you mean reducing acceleration to 80mm/s? Or did you mean from 1000 to 800?

Maybe you just needed a bit more motor current? Depends on what machine, controller, stepper driver and motors you have?

---

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions