Use of linear guides February 26, 2017 11:54PM |
Registered: 7 years ago Posts: 14 |
Re: Use of linear guides February 27, 2017 12:17AM |
Registered: 11 years ago Posts: 5,780 |
Re: Use of linear guides February 27, 2017 03:14AM |
Registered: 9 years ago Posts: 238 |
Re: Use of linear guides February 27, 2017 06:47AM |
Registered: 11 years ago Posts: 5,780 |
Re: Use of linear guides February 27, 2017 07:59AM |
Registered: 8 years ago Posts: 601 |
Re: Use of linear guides February 27, 2017 11:35AM |
Registered: 10 years ago Posts: 564 |
Re: Use of linear guides February 27, 2017 05:43PM |
Registered: 8 years ago Posts: 1,671 |
Re: Use of linear guides February 27, 2017 05:56PM |
Registered: 10 years ago Posts: 564 |
Quote
MechaBits
So what does this do? Where does the filament go?
presume your going to filp it, but cant see how you will feed it.
Re: Use of linear guides February 27, 2017 06:04PM |
Registered: 8 years ago Posts: 1,671 |
Re: Use of linear guides February 27, 2017 06:07PM |
Registered: 10 years ago Posts: 564 |
Re: Use of linear guides February 28, 2017 10:52AM |
Registered: 8 years ago Posts: 1,671 |
Re: Use of linear guides February 28, 2017 11:28AM |
Registered: 10 years ago Posts: 564 |
Quote
MechaBits
Considering the amount of plastic parts in there(even though its a minimal setup), and the size, it looks like a fairly good print, So is print just on kapton or a build surface, is that example pla?
Re: Use of linear guides February 28, 2017 05:09PM |
Registered: 9 years ago Posts: 1,873 |
Re: Use of linear guides February 28, 2017 06:14PM |
Registered: 10 years ago Posts: 564 |
Quote
JamesK
I remember when you were first building it there was a concern about how failed prints might make a mess over the hot-end - the inverted spaghetti monster problem. How has that worked out, have you had any print failures to deal with?