Cartesian Dual Z endstops

Hi,
I have a installed a Z Max endstop switch and Sensor on the Z Min.
Homing works and all the endstops report correctly on M119.

#define Z_HOME_DIR 1

I have done a lot of searching but can't find the answers....What else do I need to configure ?
Running the latest version of Marlin.

Thanks any help would be much appreciated.
Mark

To do what - home?

Set #define Z_HOME_DIR 1
ensure axis moves the right way
you might need to define
#define MANUAL_Z_HOME_POS 183 (my z-height) to set the nominal z-height (which autolevelling/grid levelling/manual levlling will override if its within 4mm - version RC8).

---

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions