Welcome! Log In Create A New Profile

SD card detection problem once removed from running Prusa i3

Posted by mRiyaz

mRiyaz

SD card detection problem once removed from running Prusa i3
January 13, 2017 11:13PM

Registered: 7 years ago
Posts: 8

Hi guys,
I have 3D Star printer, everything works fine started but lets say i stop the print and remove sd card put another. Gcode file and put it back in 3D printer gcode file shows up but i when i Try to 3d print it it shows "Print>[filename]" nothing else happens. What can i do to get it corrected?
Thanks

Reply Quote

dc42

Re: SD card detection problem once removed from running Prusa i3
January 14, 2017 01:13AM

Registered: 10 years ago
Posts: 14,672

Try sending command M21 after you replace the SD card.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

mRiyaz

Re: SD card detection problem once removed from running Prusa i3
January 14, 2017 02:03AM

Registered: 7 years ago
Posts: 8

@dc42

Sir i don't connect my laptop to my printer is there a way to send the command without laptop or pc?

Reply Quote

dc42

Re: SD card detection problem once removed from running Prusa i3
January 14, 2017 02:57AM

Registered: 10 years ago
Posts: 14,672

Quote
mRiyaz
@dc42

Sir i don't connect my laptop to my printer is there a way to send the command without laptop or pc?

Not unless your LCD panel allows you to send it. Otherwise, you will need to press the reset button on your printer electronics, or cycle the power.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].