Hello everyone,
I have a problem with inverting my inductive Sensor (
NC).
My marlin settings are:
#define Z_MIN_ENDSTOP_INVERTING false
#define Z_MIN_PROBE_ENDSTOP_INVERTING false
The results when triggering the Sensor are:
z_min: TRIGGERED
z_probe: TRIGGERED
and
z_min: open
z_probe: TRIGGERED
This means I can home the Z axis but when running the ABL, the printer acts like the Sensor is const. triggered / he is just doing the X and Y movements.
It would very nice when anyone had ideas to try out / experience.
I m not sure whether the pull up settings are relevant in that case?
Thanks a lot in advance.
I m running a Purse i3, newest Marlin Version
