Stepper motor wiring question

If I were to wire this to ramps the commonly done methods if my motors had open end cords (no 4 pin connector) what am I looking to buy exactly to stick on the end of the wires there seems to be a few different models.

What gauge are these wires commonly used on nema 17s?

Can the motor be wired to the ramps commonly done method without a 4 pin connector? (My current printer is on melzi thinking about switching it to ramps have most of the stuff have some parts I have to buy and a little information of gaps to fill in).

Here's the kit I use for the connectors: [www.amazon.com]

Nice connector set, could do with one of those. As an alternative strategy, I like to join wires with solder/heatshrink so I bought some i3 wiring kits from china which come with loads of cables with 2, 3 and 4 way connectors. Cut them and solder them where needed or use some header pins to make them into extensions. They were really cheap now I'm being quote $18 a set.

Edited 1 time(s). Last edit at 11/30/2016 06:45PM by DjDemonD.

---

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions