Hi,
I am a newbie in this subject. I bought the 200$ chinese made printer, managed to get it working after huge struggle with Chinese-English. I am using cura as slicer and set my print speed to low with a printer setting as Prusa i3 200 x 200 x 180 settings. this is as per guideline from the seller.
I do notice that sometimes during the mid print, the nozzle will travel too far to the right and hit the limit and then things start to go wrong, i.e. it will not come back to the original layer position (i.e. the centre is off now). I figure this is because it travels too much to the right of X Axis. Wonder if any of you can help with this ?
the printer purchased was : [
www.ebay.com.au]
Appreciate if you can point me into the correct direction on this subject
Thank you