Sorry for the stupid question. I have been playing with s $2,50 inductive sensor which is surprisingly accurate and consistent. In order to get the perfect Z offset I have been printing a part with the dimensions of the printable part of the heated bed and a thickness of 0,2mm (1st layer thickness). But is there a way to do this without actually printing? Can I somehow move the nozzle in the XY plane while the Z height is fixed but at the same time the printer "is doing its thing" compensating for any imperfections in the bed alignment?
Edited 1 time(s). Last edit at 11/26/2016 05:13PM by icefire.
Self-sourced Mendelmax 2.0-based Reprap Machine -- Ramps 1.4 & Mega 2560 -- DRV8825 (Z@1A,
[email protected],
[email protected], E@1A) -- genuine E3D v6 direct setup -- 350W custom silicone heated bed -- ABS 1,75mm -- Marlin 1.1.0-RC7 -- Cura 15.04.6
