stepper drivers boards too tight

Hi, I ran into this problem when attaching the stepper drivers to the RAMPS board. The stepper drivers boards are a bit too wide. Because of it, I wasn't able to push them all the way into the RAMPS board. Some of them are sitting about 1mm (or less) above the RAMPS board (please see the photo). Should I leave it as is? Or should I sand the sides of the stepper drivers boards so that they fit? Or any other advice?

They're fine the way they are.

---

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Thank you!

... but it looks better, if you file the ends to fit

---

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]

Thank you, Viktor, here is the video of the result in my signature.

---

My blog: myrobotics.ca