Welcome! Log In Create A New Profile

Advanced

{SOLVED} Broke my button.. Help me change firmware button

Posted by macsoft 
Forum List Message List New Topic
macsoft
{SOLVED} Broke my button.. Help me change firmware button
January 26, 2015 09:06AM
Yap.. while installing a knob on the jog dial of my smart LCD, I push it too far, and not I can rotate and the selections changes, but pushing the button does nothing.
The smart lcd has a "light" button that does nothing.
Where in Marlin can I assign that button instead of the push knob for selection?
thanks

Edited 1 time(s). Last edit at 01/26/2015 12:11PM by macsoft.
Reply Quote
jamesdanielv
Re: Broke my button.. Help me change firmware button
January 26, 2015 11:05AM
look in pins.h and scroll down to where your board is defined, for example motherboard == 34. somewhere in that section are buttons settings,


you can zip and upload your firmware and someone here can help you with it!
Reply Quote
macsoft
Re: Broke my button.. Help me change firmware button
January 26, 2015 11:32AM
My Marlin is fresh installed, so it should be clean as downloaded from the web.
I notice that all the LCD work is done at: dogm_lcd_implementation.h
And i can see " #define LCD_CLICKED (buttons&EN_C)" in there. But can't find out where that leads confused smiley
Reply Quote
macsoft
Re: Broke my button.. Help me change firmware button
January 26, 2015 12:11PM
OK problem solved! smiling smiley
Sometimes before finding a solution, you must first make sure you're on the best path.
I've just went the hardware way: soldered a button to the connections on the knob reserved for the internal switch smiling smiley
This will do fine until my chinese smart lcd arrives tongue sticking out smiley
Reply Quote
Attachments:
open | download - Screen Shot 2015-01-26 at 16.54.16 .jpg (454.9 KB)
open | download - Screen Shot 2015-01-26 at 16.54.07 .jpg (335.4 KB)
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login