Hello everyone.
I am currently trying to wire up an Iron 12x12 inch printer from DIY tech shop and when sending signals to the motors (via repetier) they just vibrate and but do not move.
We used the wiring diagrams from the iron 12x12 assembly instructions below.
[
shop.diytechshop.com]
After reading that they may have gotten the wiring diagrams wrong, we followed those suggested in the topic below, but unfortunately still no luck.
[
forums.reprap.org]
I emailed the guys about a week ago and have not yet received a reply. Unfortunately I wouldn't currently recommend these kits. Sub standard quality (rusty frame) with many missing parts (DIY replaced some of these which was nice, but there were many more needed), metal parts that needed some fairly serious routing to make functional and fairly poor communications. Maybe when it is up and running my qualms will go away.
Thanks in advance!
Jeremy.
Edited 1 time(s). Last edit at 12/14/2014 06:29AM by jeremy089786.