Hi all,
I have another strange problem when I enable
//#define QUICK_HOME //if this is defined, if both x and y are to be homed, a diagonal move will be performed initially.
When the X hits the end stop first it will keep driving the motor even though the optical switch triggers. Now if the Y axis hits first then the X homes normally. If I leave the Quick Home disable it will see the endstops every time and home without a problem. Sure, I could leave it disabled but this is bothering me that it doesn't work on my CoreXY. I never had this problem when I built a H-bot with the Quick Home. Any expert advice?
Thanks,
Greg
