Quote
RPearce
Hey guys, when printing vertical lines and horizontal lines with out supports which do you find works better? 1.75mm or 3mm? And what sort of heat ranges are you running when your doing it? Along with your layer thickness? Thanks for the info! This is all with ABS.
i don't really understand what you are asking
they are all horizontal lines as you are printing in slices. slices are done horizontally. and not vertical
there are usually automatic settings in your host,
repetier and slic3r sets my fan to the maximum fan speed and also has a higher speed for bridges etc.
and also my nozzle heat stays the same although printing
i am also printing in 3mm
Edited 1 time(s). Last edit at 10/19/2014 11:11AM by pushthatbolder.