Working on building my first table. Nice with liner slides but I need to use nema 23 motors with it. Using arduino 2560 with ramps 1.4 - I fried the voltage regulator right off the bat. Wired in a new one but was never able to get any control of the ramps. Tested outputs on the adunino best I could and all seemed fine but I gave and ordered another. Before trying it I have to ask if there is something I am missing with the info I can provide. I have nema 23 motors, 1.8 step, 5.1v - 1 amp. My reading says this should not be a problem. Please correct me if wrong. It seems like a lot for the ramps to handle to me. Thanks in advance. I think the motor controllers are 488's