Welcome! Log In Create A New Profile

I have 0.9 degree sterpper motors! >> what should changed in Firmware conf. file?!!!

Ibrahim Saed

I have 0.9 degree sterpper motors! >> what should changed in Firmware conf. file?!!!
April 11, 2014 06:55PM

Registered: 10 years ago
Posts: 7

Hi all,

As the subject say...
I have stepper motors with 0.9 degree/step and must use them in my RepRap project!

Can anyone tell me what should changed in Firmware code before send it to Arduino?
I will use Marlin or Sprinter Firmware.

Thanks in advance.

Reply Quote

cat.farmer

Re: I have 0.9 degree sterpper motors! >> what should changed in Firmware conf. file?!!!
April 11, 2014 07:28PM

Registered: 10 years ago
Posts: 466

Steps per unit will have to be configured correctly is all. It will end up being double of what the normal 1.8 ° would be.

Reply Quote

Ibrahim Saed

Re: I have 0.9 degree sterpper motors! >> what should changed in Firmware conf. file?!!!
April 11, 2014 08:32PM

Registered: 10 years ago
Posts: 7

Can you explain more please?!!

What the line should changed? .. And what the line contain specifically?!

Are you mean this line (in Marlin)?

uMKIcdj.png

Reply Quote

Attachments:
open | download - Configure file in marlin.png (93.3 KB)

cat.farmer

Re: I have 0.9 degree sterpper motors! >> what should changed in Firmware conf. file?!!!
April 11, 2014 09:36PM

Registered: 10 years ago
Posts: 466

Yes that is the one. Here is a calculator to help you out.[calculator.josefprusa.cz]

Reply Quote

Ibrahim Saed

Re: I have 0.9 degree sterpper motors! >> what should changed in Firmware conf. file?!!!
April 12, 2014 07:56AM

Registered: 10 years ago
Posts: 7

Thank you very much thumbs up