So, I'm waiting for my motors to arrive, but have just about everything else I need for my Prusa build.
So now I'm plotting and scheming on upgrades to it before it's even built.
I'd like to get it printing without a PC similar to how I have my makerbot setup with the interface board. I see there is an SD kit for the RAMPS board I'm using, but does Sprinter or similar software support an LCD? If so, how do I hook it up?
I believe I've seen some photos of an LCD with Sprinter firmware, but can't seem to find them now that I'm looking for it and there doesn't seem to be any reference to the LCD usage in the wiki for anything other than makerbot electronics.
Any suggestions on where I can look to help create an interface similar to the makerbot interface for my Prusas?
Thanks!